So, you want to iron on patches. That’s a smart idea—they’re easy to apply and last forever. But there are some things you need to know before you get started with this process. To give you a better understanding and guide of Iron on patches.Let’s dig in. But before we get to that, you might want to look at the fantastic possibilities for customized iron patches that are available at 4incustompatch.
Prepare the patch
Before ironing your patch, make sure it’s clean and ready to go. You’ll also want to take some time to prep the fabric where you’re going to apply it. First, press any creases out of the fabric with an iron (if applicable). Then, use a damp cloth or sponge and wipe down your project area until it’s dry. This will ensure that no moisture is left behind when you apply the adhesive backing or heat transfer paper and that your design won’t smear or shift when pressed into place.
- Place the patch on a clean, flat surface.
- Lay your garment over the patch’s top and ensure you line up all three sides.
- Turn your Iron to medium heat and place it on top of your garment for 10-15 seconds. Let cool for 30 seconds before pressing down with your hand if there are any air bubbles under the patch or wrinkles from shifting around while ironing (this is normal).
- Make sure the Iron is hot enough. The temperature should be between 300 and 350 degrees Fahrenheit.
- Iron on patches to clothing. To avoid damaging the fabric, place a piece of paper between your item and the ironing board cover or protective covering that came with your machine.
- Iron on patches to a flat surface. You can use an old sheet or tablecloth as a workspace if you don’t want to use another garment as a backdrop for your patch application.
- Iron on patches to a dry surface.*
- Make sure the patch is in the right place before ironing. This is very important! The first time you iron a new patch, it might seem difficult to get it in the right spot without moving around while ironing. But after some practice, you can quickly place your patches on your clothes and get straight to work ironing them into place.
- Place a press cloth over the area around the patch so that you don’t burn or damage any other part of your garment with stray heat from your Iron—this will also protect those areas from getting damaged by any adhesive left behind when removing or replacing a patch later.*
- Using low heat setting*, set up an old sheet or towel as an absorbent pad for patches that may drip.* For best results, use no steam on cotton fabrics.*
To ensure that your patch fully adheres, you will want to iron it on for a few seconds at a time. Make sure that the Iron is clean and dry before beginning this process. Also, double-check that your Iron’s temperature setting matches the patch’s fabric content information; this will help prevent any melting or discoloration.
- Use a damp cloth to wipe the surface clean before applying the patch.
- Iron-on patches are easy to apply and can be removed by ironing them off, so you don’t have to worry about your clothes being damaged if you get them wrong.
- It is important to use a medium heat setting when ironing on patches, as high or low settings can damage fabrics.
And that’s all there is to it! Once you have your patches on the shirt, you can wear it proudly and show everyone how fashionable you are.